кофиюта мини юбку купить.

ООО "Блок"

г. Москва,
ул. Шарикоподшипниковская, д. 13, стр. 46

Тел.: +7 (495) 287-00-38


7 Adjustment / Maintenance

7.1 In general

Before adjusting / maintaining the machine, the following has to be observed

Persons, who are working for adjusting / maintaining the machine should be aware at all times that moving machine parts can cause bodily injuries.

  • Adjusting / maintaining must be done only by trained and responsible persons
  • Before adjusting /maintaining the power supply must be cut
  • Make sure, nobody can switch on the power supply during adjustment / maintaining, thus putting the press back into operation
  • Adjusting / maintaining of the hydraulic system is only allowed with the pressure ram on lowest position and no pressure applied to the hydraulic system
  • During adjusting / maintaining, any leak of hydraulic fluid has to be absorbed with adequate binder immediately and disposed according to the local regulations and laws
  • Before putting the machine back to operation check if ll safety cover plates are remounted and check of all safety devices are OK.

7.2 Maintenance Weekly

  • Check all parts according chapter 5.4
  • Remove material accumulation from the upper side of the pressure ram
  • Check hydraulic system for leakage, hydraulic hoses for wear.
  • Any leak of hydraulic fluid has be absorbed with the adequate binder immediately and disposed according the regulations and laws!
  • Check the level of hydraulic fluid and if necessary you fill up hydraulic fluid to the bottom of the fill-up nozzle
    • Pressure ram must be in the top-up position
    • There is a gauge bar in the cover of the filling piece and the fluid level must be filled at the lower edge of the filling piece.