типография

6 - Air Adjustmnet

A - Blower Air Adjustment Knob

It is used for adjusting an air jet volume for the Blower.

If air is few, the sheet does not reach to the feeding wheel.

If air is too much, the sheet can be crashed to the wheel and error can be happened.

B - Blower Air Adjustment Knob

It is used for adjusting air vloume for the blast.

If air is few, the sheet does not reach to the feeding wheel.

If air is too much, the sheet can be crashed to the wheel and error can be happened.

  Remark: While trial operation, adjust suitable air volume.

7 - Feeding Device Handle

It is used for tightening after positioned the feeding

As shown in right picture, fix a position to the sheet using the handle.

  Remark: If the feeding device is not tightened the feeding device can be damaged while laminating.

8 - FEEDING DEVICE HEIGHT ADJUSTMENT HANDLE

It is used for adjusting the UP/DOWN position for the feeding device.

As shown in right picture, adjsut the height gap can be within 3~5mm between piled sheets and alignment device while going up the table.