ООО "Блок"

г. Москва,
ул. Шарикоподшипниковская, д. 13, стр. 46

Тел.: +7 (495) 287-00-38

email: zakaz@bloknote.net

3. The height variation is made 3~5mm between paper and allignment device when you set the feeding device as in the right picture by using the feeding device's height control handle.

If paper height is higher than allignment device, paper will be fed 2 or 3 sheets of paper and if it is too lower, it might happen to miss feeding.

Feeding Device Setting Procedure

 

Control Panel Setting

1. Set the paper length by selecting "Paper Length" in the "Main" display at the Control Panel as in the Picture<1_4>.

Control Panel Setting

Picture 1_4

2. Control Panel will appear.

Select the desired set value and press enter.

  Reference: Please insert the value 3~5mm smaller when setting the paper length since this unit is designed to be paper UNDERLAP cutting system. Paper length setting range is from "250" to "720".